#Leica gps 1200 simulator free download license

You are now able to connect to the Rover and complete the survey as per usual. ItвЂ™s usually a good idea to check the data logging status on the instrument to ensure that logging has initiated and there is sufficient space on the storage device for data. Start the base using a вЂHereвЂ™ (on System 1200, GS09) or вЂOver any pointвЂ™ (Viva). A 15 second logging rate should be sufficient for PPP. First, IвЂ™ve enabled data logging on the base sensor by going to вЂInstrumentвЂ™ > вЂBase SettingsвЂ™ > вЂRaw Data SettingsвЂ™

If the option has not been purchased, the data needs to first be converted using LGO (this will be covered later in the tutorial).ДЇor this tutorial, IвЂ™ve used two Leica GS15 GNSS sensors, and a CS15 controller to communicate with each sensor.

#Leica gps 1200 simulator free download license

If a license for on-board RINEX logging has been purchased, weвЂ™d recommend using that functionality as the RINEX file can then be uploaded onto PPP directly from the instrument. The process for survey is very similar in all Leica instruments capable of logging raw GPS data. PPP will process both GPS and GLONASS data, though it seems that there is a delay of around 24 hours after the survey until GLONASS data can be used in the correction.ДЇurther reading on PPP can be found in the user guide at: Beginning the survey: ДЄs a general rule of thumb, 40mm 3D accuracy can be achieved after 2 hours of constant occupation over a single point, and the maximum accuracy of around 10mm can be achieved after 12 hours. The following link provides detailed information regarding expected accuracies when using the service. The accuracy of PPP is directly related to the occupation period of the GNSS sensor over the base point. This tutorial provides an overview of the process involved in working with a Leica Viva Base & Rover on an arbitrary datum, then later updating the coordinates of the base and rover onto a predefined datum using PPP and Leica Geo Office.